Kiln Furniture

Setters, racks, pusher plates and posts for firing technical and electronic ceramics up to 1700 °C.

Kiln furniture carries your product through the kiln. Whether it lasts, and whether the product comes out flat and clean, depends on temperature, atmosphere, load and heating rate, more than on the industry you are in. Start from your conditions, or from the problem you see.

Choose by your conditions

Maximum service temperatures are material properties at near-zero load. Heavier loads lower the usable temperature.

ProductMax. service temperatureAtmosphereTypical use
76C / 86C-3 setter plates1700 °CAirGeneral firing of technical ceramics
86C-7, zirconia-coated—Reducing (N₂-H₂) possible after coatingMLCC base plates, footed plates
99-Z11600 °C—HTCC
99DK1700 °C—Debinding underlay; not load-bearing
Porous setters G4-1 / G5-11550 °C—Debinding, CIM, MIM, products that stick
Setter racks1400 °C—MLCC stacking
Zirconia-coated nickel meshapprox. 1300–1400 °CReducing or inert onlyMLCC, on racks
86C-3 pusher platesapprox. 1400 °C long-term—Continuous pusher kilns

"—" means please ask us for your conditions.

Or start from the problem

Plates bend or warpStart with 76C, the most deformation-resistant of the three general grades. Plates crackTry 86C-3, which resists thermal shock. The plate scratches the product86C-7 has fine grains and a smooth surface. Binder gases cannot escape, or products stickPorous setters or the 99DK plate. Firing in reducing atmosphereZirconia-coated plates and coated nickel mesh. Pusher plates crackSlow the push rate and cooling; use 86C-3.

Also available on request: saggers, and 95% and 99% alumina parts made to drawing.

Not sure where to start?

Tell us the product, size and quantity for a price, or describe your firing conditions and the problem you see. Only your email is required. We usually reply within 1–3 business days.

Request a quote